CALL US
01625-573-454

Product was successfully added to your shopping cart.
3600

Flexigas Installation

HOW TO INSTALL FLEXIGAS

STEP 1

Cut the tube supplied with a standard wheel metal pipe cutter. Make sure the cut is centrered in the valley between corrugations and carefully adjust  the cutter  on each full revolution around tube. Check the cut is clean with no sharp metal edges.

 

HOW TO INSTALL FLEXIGAS

 


STEP
 2

 

Using a sharp knife remove the yellow cover so that the last four corrugations are showing.

 

 
 
HOW TO INSTALL FLEXIGAS

 


STEP
 3

 

Place the nut over the tube and place the two semi-circular collets around it so that the ridges on the collets occupy the last three valleys of the tubing.

 

 
 
HOW TO INSTALL FLEXIGAS

 


STEP
 4

 

Ensure that the copper ring is in place on the seat inside the fitting. Tighten the fitting using two suitably sized spanners. The seal will form when the last corrugation grips the copper seat inside the fitting. Make sure that sufficient force is applied.

 

 
HOW TO INSTALL FLEXIGAS

 


STEP
 5

 

Conduct a gas tightness test then wrap the small gap  using yellow silicone tape.

 

 
HOW TO INSTALL FLEXIGAS
This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Read More...