The Heatmiser UH8-N is designed to be used with our 12v network thermostats. For Underfloor Heating - The UH1 provides central switching and is therefore ideally situated next to the underfloor heating manifold. 8 Zones can be controlled as well as providing an output for a hot water cylinder. On demand from any zone, a 230v output is provided to switch the relevant zone actuators, underfloor heating pump and valve. A volt free connection is supplied for the boiler, making it compatible with almost all types of boilers. Up to 6 actuators can be connected to each zone. An option is provided to turn zone 8 into a radiator zone. In this mode the underfloor heating pump, valve and boiler are not enabled when there is a call for heat from zone 8. Radiator System - The UH1 is not just for underfloor heating. It can equally be used in a radiator only system. The UH8-N provides a network port allowing connection to our network products, including the central Touchpad, Netmonitor and PCLink.
The Heatmiser UH1 is our central wiring switch box designed to be used with our 12v network thermostats.
The UH1 offers the following functionality;
•Central wiring to up to 8 zone actuators
•Output for under-floor heating valve and pump activated when any thermostat calls for heat
•Works with our low voltage thermostats.
•Output for a single radiator zone
•Output for domestic hot water
•Low voltage wiring to thermostats.
•Network connection to Touchpad, Netmonitor, TR2, PCLink
•Actuator outputs: 240V
Further Details - Click Here
Produt Data - click here